Connecting SAS cables to Lenovo Storage V series expansion enclosures

If you have installed expansion enclosures, you must connect them to a Lenovo Storage V series control enclosure.

This task applies if you are installing one or more expansion enclosures.

The number of SAS chains and enclosures varies per each type of system, as shown in Table 1.

Table 1. Summary of SAS chains and enclosures
System	Expansion ports	Number of SAS chains supported	Control enclosures per system	Expansion enclosures per chain	Maximum Number of Enclosures
Lenovo Storage V3700 V2 and Lenovo Storage V3700 V2 XP	Port 1 only	1	1	9^*	10
Lenovo Storage V5030	Port 1 and Port 2	2	1	10	21

Note: * 10 expansion enclosures per chain will be available after version 7.8.1.3.

Each set of expansion enclosures is connected together sequentially through the IN and OUT SAS ports, forming a chain with a control enclosure at the end of the chain.

Note: When connecting SAS cables between enclosures, you must follow a list of guidelines to ensure that your configuration is valid. Do not begin connecting the cables until you have read SAS cabling guidelines.

To install the cables, complete the following steps.

Using the supplied SAS cables, connect the control enclosure to the expansion enclosure at rack position 1, as shown in the following figures.
1. Connect SAS port 1 of the left node canister in the control enclosure to SAS port 1 of the left expansion canister in the first expansion enclosure.
2. Connect SAS port 1 of the right node canister in the control enclosure to SAS port 1 of the right expansion canister in the first expansion enclosure.
Figure 1 shows how to connect SAS cables on a Lenovo Storage V3700 V2 system.

Figure 1. Connecting the SAS cables to a Lenovo Storage V3700 V2 system

Figure 2 shows how to connect SAS cables on a Lenovo Storage V3700 V2 XP system.

Figure 2. Connecting the SAS cables to a Lenovo Storage V3700 V2 XP system

Figure 3 shows how to connect SAS cables on a Lenovo Storage V5030 system. In this figure, two expansion chains are connected to the Lenovo Storage V5030 system.

Figure 3. Connecting the SAS cables to a Lenovo Storage V5030 system
To add a second expansion chain to the Lenovo Storage V5030 control enclosure, use the supplied SAS cables to connect the control enclosure to the expansion enclosure at rack position 2, as shown in Figure 3.
Note: Lenovo Storage V3700 V2 and Lenovo Storage V3700 V2 XP systems support only one expansion chain.
1. Connect SAS port 2 of the left node canister in the control enclosure to SAS port 1 of the left expansion canister in the second expansion enclosure.
2. Connect SAS port 2 of the right node canister in the control enclosure to SAS port 1 of the right expansion canister in the second expansion enclosure.
If more expansion enclosures are installed, connect each one to the previous expansion enclosure in a chain; use two Mini SAS HD to Mini SAS HD cables, as shown in Figure 3.
If two control enclosures are installed (Lenovo Storage V5030 only), repeat this cabling procedure on the second control enclosure and its expansion enclosures.