Opening the node canister

Before you can install options in a node canister, you must gain access by opening the canister cover.

To open the canister, complete the following steps.

1. If the canister is already installed in the enclosure, remove it as shown in Figure 1.
   1. Unlatch the release levers and pull them open.
      The canister moves out of the slot approximately 0.6cm (0.25 inch).
   2. Slide the canister out of the enclosure.
   Figure 1. Removing a node canister
   

   

   
   
2. Turn the canister over and open the cover as shown in Figure 2.
   1. Press the recessed blue touch points on the cover.
   2. Slide the cover away from the thumbscrew end of the canister.
   Figure 2. Removing the canister cover