You must configure the Solaris operating system before you can use Oracle
hosts with the system.
Before you configure
the Solaris operating system, the following
tasks must be completed:
- The Lenovo Storage V series system must be
installed.
- You must install the appropriate host bus adapters.
After
the prerequisite tasks are complete, use the following
general steps to configure your Solaris operating system.
- Zone the host to the system on the Fibre Channel SAN.
- Install the appropriate multipathing driver for your host to enable the management of multiple
paths to system volumes.
Note: The subsystem device
driver (SDD) does not support
the Solaris operating system in a clustered-system environment.
- Create the host on the system by using the worldwide port names (WWPNs). Map the volumes to the
host.
- Create volumes and disks on your host by using instructions that are in your host
publications.