Use the rmmdiskgrp command to delete
a storage pool without being able to recover it.
Syntax
rmmdiskgrp [ -force ] { mdisk_group_id | mdisk_group_name }
Parameters
- -force
- (Optional) Specifies that all volumes and host mappings be deleted.
When you use this parameter, all managed disks in the storage pool
are removed and the storage pool itself is deleted.
Remember: - You must specify -force to delete a child
pool if it contains volume.
- You cannot specify -force to delete a parent pool if it has child
pools.
- mdisk_group_id | mdisk_group_name
- (Required) Specifies the ID or name of the storage pool that is
to be deleted.
Note: You cannot delete a parent pool that has child
pools. You must first delete the child pools.
Description
Important: Before you issue the command, ensure that you want
to delete all mapping information; data that is contained on volume
cannot be recovered after the storage pool has been deleted
The
rmmdiskgrp command deletes the specified storage pool. The
-force parameter is required if there are volumes that have been created from
this storage pool or if there are managed disks in the storage pool. Otherwise, the command fails.
Note: This command also removes any associated storage pool throttling.
Deleting a storage pool is essentially
the same as deleting a clustered system (system) or part of a system,
because the storage pool is the central point of control of virtualization.
Because volumes are created using available extents in the storage
pool, mapping between volume extents and managed disk extents is controlled
based on the storage pool.
The command deletes all volume copies
in the specified storage pool. If the volume has no remaining synchronized
copies in other storage pools, the volume is also deleted.
This command deletes the associated MDisk
group (storage pool) throttle if that storage pool is removed.
Remember: This command is unsuccessful
if:
- Volume protection is enabled (using the chsystem command)
- The MDisk being removed is mapped to any volume that has received
I/O within the defined volume protection time period
Remember: This command partially completes
asynchronously. All volumes, host mappings, and Copy Services
relationships are deleted before the command completes. The
deletion of the storage pool then completes asynchronously.
In
detail, if you specify the
-force parameter and
the volumes are still using extents in this storage pool, the following
actions are initiated or occur:
- The mappings between that disk and any host objects and the associated
Copy Services relationships are deleted.
- If the volume is a part of a FlashCopy mapping,
the mapping is deleted.
Note: If the mapping is not in the idle_or_copied
or stopped states, the mapping is force-stopped and then deleted.
Force-stopping the mapping might cause other FlashCopy mappings in the system to also
be stopped. See the description for the -force parameter
in the stopfcmap command for additional information.
- Any volume that is in the process of being migrated into or out
of the storage pool is deleted. This frees up any extents that the
volume was using in another storage pool.
- Volumes are deleted without first flushing the cache. Therefore,
the storage controller LUNs that underlie any image mode MDisks might
not contain the same data as the image mode volume prior to the deletion.
- If there are managed disks in the storage pool, all disks are
deleted from the storage pool. They are returned to the unmanaged
state.
- The storage pool is deleted.
Attention: If you use the -force parameter
to delete all the storage pools in your system, you are returned to
the processing state where you were after you added nodes to the system.
All data that is contained on the volumes is lost and cannot be
recovered.
An invocation example
rmmdiskgrp -force Group3
The
resulting output:
No feedback