Ensure that you understand the caution notices for the
Lenovo Storage V series.
CAUTION:
The battery contains lithium. To avoid possible explosion, do not
burn or charge the battery.
Do not: Throw or immerse into water, heat to more than 100°C (212°F),
repair or disassemble. (C003)
CAUTION:
Removing components from the
upper positions in the rack cabinet improves rack stability during
a relocation. Follow these general guidelines whenever you relocate
a populated rack cabinet within a room or building.
- Reduce the weight of the rack cabinet by removing equipment starting
at the top of the rack cabinet. When possible, restore the rack cabinet
to the configuration of the rack cabinet as you received it. If this
configuration is not known, you must observe the following precautions.
- Remove all devices in the 32U position and above.
- Ensure that the heaviest devices are installed in the bottom
of the rack cabinet.
- Ensure that there are no empty U-levels between devices installed
in the rack cabinet below the 32U level.
- If the rack cabinet you are relocating is part of a suite of rack
cabinets, detach the rack cabinet from the suite.
- If the rack cabinet you are relocating was supplied with removable
outriggers they must be reinstalled before the cabinet is relocated.
- Inspect the route that you plan to take to eliminate potential
hazards.
- Verify that the route that you choose can support the weight of
the loaded rack cabinet. Refer to the documentation that comes with
your rack cabinet for the weight of a loaded rack cabinet.
- Verify that all door openings are at least 760 x 230 mm (30 x
80 in.).
- Ensure that all devices, shelves, drawers, doors, and cables are
secure.
- Ensure that the four leveling pads are raised to their highest
position.
- Ensure that there is no stabilizer bracket installed on the rack
cabinet during movement.
- Do not use a ramp inclined at more than 10 degrees.
- When the rack cabinet is in the new location, complete the following
steps:
- Lower the four leveling pads.
- Install stabilizer brackets on the rack cabinet.
- If you removed any devices from the rack cabinet, repopulate the
rack cabinet from the lowest position to the highest position.
- If a long-distance relocation is required, restore the rack cabinet
to the configuration of the rack cabinet as you received it. Pack
the rack cabinet in the original packaging material, or equivalent.
Also lower the leveling pads to raise the casters off the pallet and
bolt the rack cabinet to the pallet. (R002)
CAUTION:
- Rack is not intended to serve as an enclosure and does not provide
any degrees of protection required of enclosures.
- It is intended that equipment installed within this rack will
have its own enclosure. (R005).
CAUTION:
Tighten the stabilizer
brackets until they are flush against the rack. (R006)
CAUTION:
Use safe practices when lifting. (R007)
CAUTION:
Do not place any object on top of
a rack-mounted device unless that rack-mounted device is intended
for use as a shelf. (R008)
CAUTION:
If
the rack is designed to be coupled to another rack only the same model
rack should be coupled together with another same model rack. (R009)