A problem occurs only occasionally
and is difficult to diagnose. |
- Make sure that:
- All cables and cords are connected securely to the rear of the
server and attached devices.
- When the server is turned on, air is flowing from the fan grille.
If there is no airflow, the fan is not working. This can cause the
server to overheat and shut down.
- Check the system-error log or IMM event logs (see Event logs).
|
The server resets (restarts) occasionally. |
- If the reset occurs during POST and the POST watchdog timer is
enabled (click in the Setup
Utility to see the POST watchdog setting), make sure that sufficient
time is allowed in the watchdog timeout value (). If the server continues
to reset during POST, see UEFI/POST diagnostic codes and DSA diagnostic test results.
- If neither condition applies, check the system-error log or IMM
system-event log (see Event logs).
|