Completing the installation

Use this information to complete the installation.

To complete the installation, complete the following steps:

1. If you removed any air baffles, reinstall them (see Installing the microprocessor 2 air baffle and Installing the DIMM air baffle).
2. If you removed the cover, replace it (see Installing the cover).
3. Install the server in the rack cabinet (see the Rack Installation Instructions that come with the server for instructions).
4. Reconnect the cables and power cords (see Connecting the cables).
5. Update the server configuration (see Updating the server configuration).
6. Slide the server back into the rack, if necessary.
7. Start the server. Confirm that it starts correctly and recognizes the newly installed devices, and make sure that no error LEDs are lit.
8. (IBM Business Partners only) Complete the additional steps in Instructions for IBM Business Partners.

• Installing the microprocessor 2 air baffle
  Use this information to install the microprocessor 2 air baffle.
• Installing the DIMM air baffle
  Use this information to install the DIMM air baffle.
• Installing the cover
  Use this information to install the cover.
• Connecting the cables
  The following illustrations show the locations of the input and output connectors of the server.
• Updating the server configuration
  When you start the server for the first time after you add or remove a device, you might receive a message that the configuration has changed. The Setup utility starts automatically so that you can save the new configuration settings.