Skip to main content

Installing a USB embedded hypervisor flash device

Use this information to install a USB embedded hypervisor flash device.

To install a hypervisor flash device, complete the following steps:

  1. Read the safety information that begins in Safety and Installation guidelines.
  2. Turn off the server (see Turning off the server) and all attached peripheral devices. Disconnect all power cords; then, disconnect all external cables from the server.
  3. Remove the top cover (see Removing the server top cover).
  4. Remove PCIe riser-card assembly 1 (see Removing a PCI riser-card assembly).
  5. Locate the embedded hypervisor USB flash device connector on the system board as shown in the following illustration:
    Figure 1. Location of the embedded hypervisor USB flash device
    Location of the embedded hypervisor USB flash device
  6. Slide the lockbar toward the riser-card assembly to the locked position until it is seated firmly.
    Figure 2. Embedded hypervisor USB flash device installation
    Embedded hypervisor USB flash device installation

If you have other devices to install or remove, do so now. Otherwise, go to Completing the installation.