Replacing the 240 VA safety cover

Use this information to replace the 240 VA safety cover.

Read the safety information in Safety and Installation guidelines.

If you are replacing a server component in the server, you need to slide the server out from the rack enclosure, turn off the server and peripheral devices, and disconnect the power cords and all external cables.

To replace the 240 VA safety cover, complete the following steps:

1. Align the safety cover with the standoffs on the power paddle card and lower the safety cover onto the power paddle card until it is secure.
   Figure 1. 240 VA safety cover installation
   
   
2. Install the four screws to secure the safety cover.
   Figure 2. 240 VA safety cover's screws
   
   
3. Reconnect any SAS/SATA signal cable and all other cables that you have removed previously (see Internal cable routing and connectors).
4. Reinstall the cover (see Replacing the cover).

What to do next

1. Install the server into the rack enclosure and push the server into the rack until it clicks into place.
2. Reconnect the power cords and any cables that you removed.
3. Turn on the peripheral devices and the server.