Using the embedded hypervisor

The VMware ESXi embedded hypervisor is available on the optional Lenovo USB flash device.

The USB flash device can be connected to the USB connectors on the system board. To locate the connectors, see System-board connectors. Hypervisor is a type of software that enables multiple operating systems to run on a host system at the same time. The USB flash device is required to activate the hypervisor.

To start using the embedded hypervisor, you must add the USB flash device to the startup sequence in the Setup Utility.

To add the USB flash device to the startup sequence, do the following:

1. Turn on the server.
   Note

   Approximately 5 seconds after the server is connected to power, the power-control button becomes active.
2. When the prompt <F1> Setup is displayed, press F1.
3. From the Setup Utility main menu, select Boot Manager.
4. Select Add Boot Option; then, select Generic Boot Option > Embedded Hypervisor. Press Enter, and then press Esc.
5. Select Change Boot Order > Change the order. Use the up and down arrow keys to select Embedded Hypervisor and use the plus (+) and minus (-) keys to move Embedded Hypervisor in the boot order. When Embedded Hypervisor is in the correct location in the boot order, press Enter. Select Commit Changes and press Enter.
6. Select Save Settings and then select Exit Setup.

If the embedded hypervisor flash device image becomes corrupt, you can download the image from the IBM x86 solutions for VMware vSphere Hypervisor website.

For additional information and instructions, see VMware vSphere documentation at the VMware vSphere documentation website.