Skip to main content

Memory problems

Note
Each time you install or remove a DIMM, you must disconnect the server from the power source; then, wait 10 seconds before restarting the server.
Table 1. Memory problems and actions.

The memory problems and actions table with one level of row and column headers.

SymptomAction
The amount of system memory that is displayed in Setup Utility is less than the amount of installed physical memory.
  1. Make sure that:
    • No error LEDs are lit on the operator information panel.
    • No DIMM error LEDs are lit on the system board.
    • The memory modules are seated correctly.
    • You have installed the correct type of memory.
    • If you changed the memory, you updated the memory configuration in the Setup Utility.
    • All banks of memory are enabled. The server might have automatically disabled a memory bank when it detected a problem, or a memory bank might have been manually disabled.
    • There is no memory mismatch when the server is at the minimum memory configuration.
  2. Reseat the DIMMs, and then restart the server.
  3. Check the POST error log:
    • If a DIMM was disabled by a system-management interrupt (SMI), replace the DIMM.
    • If a DIMM was disabled by the user or by the POST, reseat the DIMM; then, run the Setup Utility and enable the DIMM.
  4. Check that all DIMMs are initialized in the Setup Utility; then, run memory diagnostics. See Running DSA Preboot diagnostic program.
  5. Add one pair of DIMMs at a time, making sure that the DIMMs in each pair match.
  6. Reseat the DIMM.
  7. Re-enable all DIMMs using the Setup Utility, and then restart the server.
  8. Replace the following components one at a time, in the order shown, restarting the server each time:
    1. DIMMs
    2. (Trained technician only) system board
Multiple rows of DIMMs in a branch are identified as failing.
  1. Reseat the DIMMs; then, restart the server.
  2. Replace the failing DIMM.
  3. (Trained technician only) Replace the system board
A memory error occurs indicating that one memory module in a channel is failing.For example, if you suspect memory module in slot 1 or slot 2 is failing, do the following:

  1. Exchange memory module in slot 1 with memory module in slot 3.

  2. Restart the server.

  3. Check whether this error still occurs.

    1. If yes, it means that memory module in slot 2 is failing. Then, replace memory module in slot 2 with a new memory module.

    2. If no, it means that memory module in slot 1 is failing. Then, replace memory module in slot 1 with a new memory module.

For more information, refer to the tip files at: the Lenovo Support Portal