Example iSCSI configurations

Configure your Lenovo Storage V7000 in a network that uses Internet Small Computer System Interface (iSCSI).

Figure 1 shows a two-nodeLenovo Storage V7000clustered system that is connected to a single subnet. Each node has two Ethernet ports, each of which is used for iSCSI data transfers. One node in the system also acts as the system configuration node. In this example, port 1 on the configuration node provides the system management IP interface.

Figure 1. iSCSI configuration with a single subnet

Figure 2 shows a two-node Lenovo Storage V7000system that is connected to multiple subnets. Each node has two Ethernet ports (port 1 and port 2) that are connected to different IP subnets. In addition, one node in the system also acts as the system configuration node, which provides alternate IP interfaces, again on different subnets for the system management interface.

Note: With a multiple subnet configuration, if one subnet fails and the iSNS server is part of that subnet, the nodes and hosts are not able to access the iSNS server. The I/O is not affected and the other subnet is still active.

Figure 2. iSCSI configuration that uses multiple subnets and provides alternate configuration interfaces

Figure 3 shows the same two-node Lenovo Storage V7000system as Figure 2. This figure illustrates the benefits of using multipathing and redundant host interface adapters in the host systems.

Figure 3. iSCSI configuration with host multipathing

In this example, host 1 does not use multipathing. A volume in the Lenovo Storage V7000 I/O group appears as four separate devices in host 1. The host selects one device to perform I/O to the volume, which corresponds to a particular IP address at a Lenovo Storage V7000 node port, 10.10.1.10. If a connection between the host and this Lenovo Storage V7000 port is broken (the link at X is broken), an I/O error is recorded on host 1 for that volume if I/O is in progress. No Lenovo Storage V7000 state changes or IP failover occur.

Host 2 uses multipathing. A volume in the Lenovo Storage V7000 I/O group appears as a single device to the applications on host 2, even though the multipathing driver can detect four separate devices for each volume. The multipathing driver selects one or more of these devices during I/O. If the connection between the host and one Lenovo Storage V7000 node port is lost, the multipathing driver can select an alternative path to the Lenovo Storage V7000 I/O group. The I/O between the host and Lenovo Storage V7000 continue without error. Host 2, however, has only one host interface adapter and will therefore report I/O errors (such as the link at Y is broken) if the connection between that host interface adapter and the network is lost.

Host 3 uses multipathing and redundant host interface adapters. This means that if a host interface adapter fails, the multipathing driver can still find paths from the host to a volume in the Lenovo Storage V7000 I/O group and the application I/O can continue without error. Because the host interface adapters are connected to different IP networks, the overall configuration can tolerate a single network failing without I/O errors occurring on host 3.

Multipathing drivers are not required to do system maintenance when Lenovo Storage V7000 nodes are removed or replaced in an I/O group. However, multipathing host drivers are required for load balancing and for surviving host interface adapter, link, or network failures.