Port settings for HP MA and EMA systems

Port settings are configurable at the port level.

Restriction: Only one port per HSG80 pair can be used with the system.

The port settings are set by using the following commands:

SET THIS PORT_1_TOPOLOGY=FABRIC
SET THIS PORT_2_TOPOLOGY=FABRIC
SET OTHER PORT_1_TOPOLOGY=FABRIC
SET OTHER PORT_2_TOPOLOGY=FABRIC

These values can be checked by using the following commands:

SHOW THIS
SHOW OTHER

Supported HSG80 controller port settings lists the HSG80 controller port settings that the system supports.

Table 1. Supported HSG80 controller port settings
Option	HSG80 default setting	Required system setting
PORT_1/2-AL-PA	71 or 72	Not applicable
PORT_1/2_TOPOLOGY	Not defined	FABRIC

Note: The HP MA and EMA systems support LUN masking that is configured with the SET unit number ENABLE_ACCESS_PATH command. When used with the system, the access path must be set to all (SET unit number ENABLE_ACCESS_PATH=ALL). All LUN masking must also be handled exclusively by the system. You can use the SHOW CONNECTIONS FULL command to check access rights.