Reset service IP address and superuser password command

Use this command to obtain service assistant access to a node canister even if the current state of the node canister is unknown. The physical access to the node canister is required and is used to authenticate the action.

Syntax

 satask  chserviceip    -serviceipipv4   [ -gwipv4 ]   [ -maskipv4 ]   [  -resetpassword  ]
 satask  chserviceip    -serviceip_6ipv6   [ -gw_6ipv6 ]   [ -prefix_6int ]   [ -resetpassword ]  
 satask  chserviceip    -default   [ -resetpassword ]

Parameters

-serviceipipv4
(Optional) The IPv4 address for the service assistant.
-gwipv4
(Optional) The IPv4 gateway for the service assistant.
-maskipv4
(Optional) The IPv4 subnet for the service assistant.
-serviceip_6ipv6
(Optional) The IPv6 address for the service assistant.
-gw_6ipv6
(Optional) The IPv6 gateway for the service assistant.
-default
(Optional) Resets to the default IPv4 address.
-prefix_6int
(Optional) The IPv6 prefix for the service assistant.
-resetpassword
(Optional) Sets the service assistant password to the default value.

Description

This command resets the service assistant IP address to the default value. If the command is run on left canister, the default value is 192.168.70.121 subnet mask: 255.255.255.0. If the command is run on right canister, the default value is 192.168.70.122 subnet mask: 255.255.255.0. If the node canister is active in a system, the superuser password for the system is reset; otherwise, the superuser password is reset on the node canister.

If the node canister becomes active in a system, the superuser password is reset to that of the system. You can configure the system to disable resetting the superuser password. If you disable that function, this action fails.

This action calls the satask chserviceip command and the satask resetpassword command.